Towing Setup & Capacity
Tongue Weight Calculator
Enter what the trailer weighs packed the way you tow it. You get the tongue weight band to aim for, the hitch class that band needs, and what to weigh it with.
By Mike M. ·
How this page is funded: we earn a commission if you buy through our links, at no extra cost to you. It never changes which product we rank first. Prices come from Amazon and are read automatically — each one shows the date it was read. Full disclosure.
The short answer
What the trailer weighs packed the way you tow it — water in the tanks you fill, gear in the front storage. Not the brochure dry weight.
Your tongue weight target
600–900lb
10–15% of loaded trailer weight, the published band for a ball coupler.
720lb
Aim here. 12% sits in the middle of the band and leaves room either side as you load.
- Hitch class this needs
- Class 3 or above — 2 in receiverAt the top of the band (900 lb) you would be into Class 4 territory
- What this weight sits on
- Your vehicle’s payload, not its towing capacity
Check the figure stamped on your own receiver against this: the full class table lists what each one is rated for, and the lower of the hitch rating and the vehicle rating is always your limit.
Weigh it, do not estimate it
The number above is the target. A tongue scale is how you find out what you actually have.
Price as of November 18, 2026. #ad How this is funded
At this tongue weight
Most tow-vehicle manuals require weight distribution somewhere in this range. Match a bar rating to your tongue weight.
Price as of November 18, 2026. #ad How this is funded
Tongue weight: the downward force the trailer’s coupler puts on the hitch ball with the trailer packed the way you actually travel. It is not the dry hitch weight on the brochure, which is measured with empty tanks and nothing loaded, and it is routinely 100–250 lb lower than the real figure.
Why 10-15%, and where the band comes from
Too little tongue weight and the trailer pushes the back of the tow vehicle around: the coupler acts as a pivot and any disturbance — a truck passing, a crosswind, a lane change — starts an oscillation that grows instead of damping. Too much and the rear axle squats, the front tires unload, and the steering and braking the vehicle was designed around stop working properly. The band is the range where neither happens.
| Coupler type | Tongue weight band | Aim for | On a 6,000 lb trailer |
|---|---|---|---|
| Conventional ball coupler | 10-15% | 12% | 600-900 lb, aim 720 lb |
| Fifth wheel | 15-25% | 20% | 900-1,500 lb, aim 1,200 lb |
| Gooseneck | 15-25% | 20% | 900-1,500 lb, aim 1,200 lb |
The gap between the two is structural rather than arbitrary. A ball coupler hangs its load behind the rear axle, where every pound acts on a lever; a fifth wheel or gooseneck puts its load in the bed, ahead of or over the rear axle, where the vehicle can carry far more of it. That is also why the two are rated so differently: SAE J684 covers couplings and hitches, and the maker’s own rating plate is the figure that applies to the part on your vehicle.
What your tongue weight means for hitch class
A receiver carries two published ratings, gross trailer weight and tongue weight, and you have to clear both. The calculator names the lowest class that covers the figure it tells you to aim for, and then says when the top of your band would push you into the next class up — because a tongue-weight rating is a hard limit and loading drifts upward over a season, not down.
| Class | Receiver | Gross trailer weight | Tongue weight |
|---|---|---|---|
| Class 1 | 1-1/4 in | 2,000 lb | 200 lb |
| Class 2 | 1-1/4 in | 3,500 lb | 350 lb |
| Class 3 | 2 in | 8,000 lb | 800 lb |
| Class 4 | 2 in | 10,000 lb | 1,000 lb |
| Class 5 | 2-1/2 in or 3 in | 17,000 lb and up | 1,700 lb and up |
Travel trailers land in Class 3 or above almost without exception. The full hitch class table has the whole set, and what a class 2 trailer hitch can tow against a class 3 covers the step most people are deciding between.
The number this comes out of
Tongue weight is carried by the tow vehicle’s payload, not by its towing capacity. It lands on the rear axle along with the passengers, the cargo and the hitch hardware itself, and payload is the limit most people hit first and notice last. A 720 lb tongue on a truck with 1,500 lb of payload has already spent nearly half of it before anybody gets in.
Payload vs towing capacity sets the two side by side, and the towing capacity calculator does the combination-weight arithmetic for the same rig.
The common mistake
How to find your actual tongue weight
The calculator gives you a target. A tongue scale gives you the truth, and the two are often several hundred pounds apart on a trailer packed for a real trip. How to measure tongue weight covers the scale method and the public-scale method step by step, and the tongue weight scale picks are the hardware for it.
What to remember
- 10-15% on a ball coupler, 15-25% on a fifth wheel or gooseneck. Aim for the middle.
- Size the hitch class to the TOP of your band, not the bottom.
- Tongue weight comes out of payload, not towing capacity.
- The loaded weight is the one that counts - never the brochure dry weight.
Common questions
10–15% of loaded trailer weight on a ball coupler, 15–25% on a fifth wheel or gooseneck. Aim for the middle of the band, not the edge.
Multiply the loaded trailer weight by 0.10 and 0.15 for a ball coupler, or 0.15 and 0.25 for a fifth wheel. The calculator above does it and names the hitch class the answer needs.
Payload. It presses down on the vehicle, so it sits with the passengers and the cargo — not against the towing capacity. Why that matters.
It sways. Too little weight on the ball lets the trailer pivot, and a disturbance builds instead of settling. Move load forward of the axles first. What causes sway.
No. It moves where the weight is carried, off the rear axle and onto the front axle and the trailer axles. The tongue weight itself is the same, and it still counts against payload.
Sources
- SAE J2807 — tow-vehicle performance and gross combination weight rating procedure — read November 2026
- SAE J684 — trailer couplings, hitches and safety chains — read November 2026
- 49 CFR 393.70 — coupling devices and towing methods — read November 2026
- NHTSA — vehicle certification label and load-carrying capacity — read November 2026
- CURT published towing product specifications — read November 2026